Drilled 125B Mammoth Enclosure materials are widely used in life or in some industrial equipment. Some of the benefits of aluminum materials must be known to everyone. Then Drilled 125B Mammoth Enclosure is widely used by some equipment. We need to produce Drilled 125B Mammoth Enclosure. Which ones should I pay attention to?

On the one hand, the quality of Drilled 125B Mammoth Enclosure material comes from the unevenness of the aluminum element contained in its own raw materials, and on the other hand, it comes from the technical control during the production process. However, no matter what aluminum profile is, it must pay attention to an aging technology, that is, in the production process. Every link in this has a time-sensitive control.

Aging technology in the production process of Drilled 125B Mammoth Enclosure:

1. General curtain wall profiles, general door and window profiles, and industrial profiles must be aging in the same aging furnace. The temperature in the furnace is controlled within the range of 195℃±5℃. After reaching the temperature, the furnace is kept for 3 hours and the furnace is turned on for 20 minutes. After cooling, the quality inspector checks the hardness.
2. If the aging heat insulation profile is not full of the furnace, you can put 1 to 2 frames of general profiles (the wall thickness is less than 2.0mm) for aging in the same furnace, and the aging technology is according to the partition. An aging furnace is aging. The temperature in the furnace is controlled within the range of 180°C±3°C. After reaching the temperature, the furnace is held for 3 hours and the air blower is turned on for 20 minutes to cool down. The quality inspector checks the hardness.
4. When the temperature in the furnace reaches the technically required temperature, the aging worker uses a glass tube thermometer to measure the actual temperature in the furnace every 30 minutes and make original records.
5. When lifting the material into the furnace, the end of the profile and the air guide should be controlled within 80-100mm.

Only by rigorously controlling every aging link as above can we ensure the function and quality of the Drilled 125B Mammoth Enclosure products shipped from the factory.