Many times, I will encounter some customized 1590XX 1790NS Cast Aluminum Enclosure. If the aluminum alloy has low hardness, it is easy to deform after processing. If some large customized 1590XX 1790NS Cast Aluminum Enclosure parts are encountered, in order to prevent deformation, prevent deformation before mold opening and rough machining. Roughly open the contour structure, and then flatten the front and back to make it vertical, and then use the machine to make the front and back of the light knife. If the side wall of the workpiece is thin, it must be thermally hardened before placing the machine. The thickness can also be reserved according to the structure of the workpiece. Then straighten the perpendicularity of the parallelism of the workpiece, and brush the entire plane of the workpiece. It can also solve the problem of workpiece deformation.

If it is a relatively small customized 1590XX 1790NS Cast Aluminum Enclosure, then the product plane should be flush with the worktable, and there should be no gaps when making the reverse side. Then you can use the reverse side to solve the problem of deformation, or you can flatten the wool first, and then use the side as the bottom surface. Then use the other side as the front side, so that the workpiece can be vertical and the workpiece will not be deformed too much.

For some thinner customized 1590XX 1790NS Cast Aluminum Enclosure, it is reasonable to make side fashion clips. It is not possible to clamp the workpiece without force by using the bow clamp. It is best to flatten the workpiece with a right-angle iron, and then use a bow clamp to clamp the workpiece to a flat place with the right-angle iron. In many cases, the deformation is caused by improper clamping.